Start Hanging Wallpaper Feature Wall

Apply paste to the plate then lay it face down on the paper.

Start hanging wallpaper feature wall.

If the window is the only feature in the room that you can use as your starting point measure the window and mark the center line. You can use a wallpaper smoothing tool to eliminate creases and bubbles. Plan to lay seams where they ll be the least noticeable. If you re hanging wallpaper on new drywall prime the wall first with wallpaper primer to seal the drywall and help the paper adhere to the wall.

Here are the steps to planning for success. Apply the top half of the strip to the wall slightly overlapping the ceiling and adjoining wall. Mix the wallpaper paste with the amount of water that it says on the packet and leave it to stand for a few minutes. The first length is hung with its edge on the mid point line.

Wash any dirt or dust from the old walls and sand smooth any chipped paint. This has been made simpler because there s no need to apply the paste to the wallpaper fold it and let it soak in before hanging it. You can use a spirit level instead if you prefer. Cut a piece of paper a few inches longer than you need.

Decorator for 30 years harry anstice shows you how to wallpaper a feature wall quickly and effectively. Hang first strip start at your plumb line and ensure the pattern is right side up. Hang wallpaper to create a feature wall hanging wallpaper isn t as complicated as it might seem thanks to new techniques like paste the wall wallpaper. Next pull out the tacks and remove excess fabric along the ceiling and corners with a box cutter.

When it is time to switch things up use water to dampen one of the fabric s edges and slowly peel off. Although seam planning. Hold them both on the wall and adjust the paper to match the pattern on the wall. Wallpaper from cole and son wallpapers donated by www.

How to wallpaper a feature wall. You then continue to hang full lengths either side of this until you reach the corners. Using a plumb line and pencil mark a vertical line on the wall. Hang the first piece to the right of the line and the second piece to the left.

Cut from the part of the pattern that matches the paper on the wall around the switch. Slide the wallpaper into position lining up with the plumb line. Remove electrical outlet and light switch covers. The seam should be exactly on the line and plumb.

Which is the dominant wall. Notice that you are left with two narrower lengths in this situation one full length can be cut in half. Afterward let your new feature wall dry overnight. Remove old wallpaper using wallpaper remover a wide blade and rags.